Fanuc PROF Alarm Codes

Home > Fanuc > Alarm Codes > PROF Alarm Codes

Fanuc PROF Alarm Codes

PROF-000 STOP System error(%d)
Cause: System internal error
Remedy: Document the events that led to the error, and call your FANUC Robotics technical
service representative.
________________________________________________________________
PROF-001 WARN PROFIBUS PCB not installed
Cause: PROFIBUS is not installed
Remedy: Please install PROFIBUS PCB.
________________________________________________________________
PROF-002 STOP PROFIBUS PCB abnormal(%d)
Cause: PROFIBUS PCB is abnormal.
Remedy: Please exchange PROFIBUS PCB
________________________________________________________________
PROF-003 STOP Slave Config data error
Cause: Configuration data is abnormal.
Remedy: Please change configuration data on Master
________________________________________________________________
PROF-004 STOP Slave Param data error
Cause: Parameter data is abnormal.
Remedy: Please change parameter data on Master
________________________________________________________________
PROF-005 STOP Master Slave Param error(%d)
Cause: Slave Parameter sets is abnormal.
Remedy: Please change Slave Parameter sets on the Master.
________________________________________________________________
PROF-006 STOP Another Master Lock(%d)
Cause: Setting of slave is abnormal.
Remedy: Please change slave setting.
________________________________________________________________
PROF-007 STOP Parameter Fault(%d)
Cause: Setting of slave is abnormal.
Remedy: Please change slave setting.
________________________________________________________________
PROF-008 STOP Invalid Slave Responce(%d)
Cause: Setting of slave is abnormal.
Remedy: Please change slave setting.
________________________________________________________________
PROF-009 STOP Slave not supported(%d)
Cause: Setting of slave is abnormal.
Remedy: Please change slave setting.
________________________________________________________________
PROF-010 STOP Config Fault(%d)
Cause: Setting of slave is abnormal.
Remedy: Please change slave setting.
________________________________________________________________
PROF-011 STOP Slave not ready(%d)
Cause: Setting of slave is abnormal.
Remedy: Please change slave setting.
________________________________________________________________
PROF-012 STOP Slave not existent(%d)
Cause: Setting of slave is abnormal.
Remedy: Please change slave setting.
________________________________________________________________
PROF-013 STOP CMI error(code = %d)
Cause: Master firmware is abnormal.
Remedy: Please exchange PROFIBUS PCB
________________________________________________________________
PROF-014 STOP DP error(code = %d)
Cause: Master firmware is abnormal.
Remedy: Please exchange PROFIBUS PCB
________________________________________________________________
PROF-015 STOP DP sub error(code = %d)
Cause: Master firmware is abnormal.
Remedy: Please exchange PROFIBUS PCB
________________________________________________________________
PROF-017 STOP Slave disconnected
Cause: Slave is disconected.
Remedy: Please connect cable to Slave.
________________________________________________________________
PROF-018 STOP Exist specific diag(%d)
Cause: A status message exists in the slave specific diagnostic area in the received diagnostic data.
Remedy: Please invstigate the specific diagnostic data.
________________________________________________________________
PROF-019 STOP Multi-boards are not supported
Cause: Multiple Profibus boards are not supported.
Remedy: Please set only one Profibus board.