Fanuc SRIO Alarm Codes

Home > Fanuc > Alarm Codes > SRIO Alarm Codes

Fanuc SRIO Alarm Codes

SRIO-001 WARN S. PORT ILLEGAL FUNCTION CODE
Cause: Illegal function code was specified. System error.
Remedy: System error.
________________________________________________________________
SRIO-002 WARN SERIAL PORT NOT OPEN
Cause: Serial port is not opened.
Remedy: Open serial port before using it.
________________________________________________________________
SRIO-003 WARN SERIAL PORT ALREADY OPEN
Cause: Serial port has already been opened, and it was tried to be opened again.
Remedy: Do not try to open the serial port which has already be opened.
________________________________________________________________
SRIO-004 WARN SERIAL PORT NOT INITIALIZE
Cause: Serial port is not initialized.
Remedy: Initialize the serial port before using it.
________________________________________________________________
SRIO-005 WARN SERIAL PORT DSR OFF
Cause: Serial port DSR is off.
Remedy: Check if serial port setup is correct. Check if cable is broken. Check if there exists a noise
source near controller. Check target device status.
________________________________________________________________
SRIO-006 WARN SERIAL PORT PARITY ERROR
Cause: Serial port parity error occured.
Remedy: Check if serial port setup is correct. Check if cable is broken. Check if there exists a
noise source near controller.
________________________________________________________________
SRIO-007 WARN SERIAL PORT OVERRUN ERROR
Cause: Serial port overrun error occured.
Remedy: Check if serial port setup is correct. Check if cable is broken. Check if there exists a
noise source near controller.
________________________________________________________________
SRIO-008 WARN SERIAL PORT FRAME ERROR
Cause: Serial port frame error occured.
Remedy: Check if serial port setup is correct. Check if cable is broken. Check if there exists a
noise source near controller.
________________________________________________________________
SRIO-009 WARN S. PORT PARITY &OVERRUN
Cause: Serial port parity error and overrun error occured.
Remedy: Check if serial port setup is correct. Check if cable is broken. Check if there exists a
noise source near controller.
________________________________________________________________
SRIO-010 WARN S. PORT PARITY &FRAME
Cause: Serial port parity error and frame error occured
Remedy: Check if serial port setup is correct. Check if cable is broken. Check if there exists a
noise source near controller.
________________________________________________________________
SRIO-011 WARN S. PORT OVERRUN &FRAME
Cause: Serial port overrun error and frame error occured.
Remedy: Check if serial port setup is correct. Check if cable is broken. Check if there exists a
noise source near controller.
________________________________________________________________
SRIO-012 WARN S. PORT PRTY &OVRRN &FRM
Cause: Serial port parity error, overrun error, and frame error occured.
Remedy: Check if serial port setup is correct. Check if cable is broken. Check if there exists a
noise source near controller.
________________________________________________________________
SRIO-013 WARN S. PORT DSR OFF &HARDWARE ERR
Cause: Serial port DSR is off and harware error occured.
Remedy: Check if serial port setup is correct. Check if cable is broken. Check if there exists a noise
source near controller. Check target device status. Check the hardware.
________________________________________________________________
SRIO-014 WARN S. PORT ILLEGAL REQUEST COUNT
Cause: Serial port request count is illegal. System error.
Remedy: System error.
________________________________________________________________
SRIO-015 WARN SERIAL PORT CANCEL
Cause: Cancel current serial port setup. This code does not appear at normal time. System error.
Remedy: System error.
________________________________________________________________
SRIO-016 WARN S. PORT POWER FAILURE CANCEL
Cause: Initialize serial port at power failure recovery. This code does not appear at normal time.
System error.
Remedy: System error.